Clarification from the agency

Open to Areas 1. DEFINITION FOR AREAS OF CONSIDERATION IN ADDITIONAL INFORMATION

Position Description # D1202000

POSITION DUTIES: This position is located in the Joint Forces Headquarters-State, Logistics Directorate (J-4), Surface Maintenance Facility. The primary purpose of this position is to perform calibration, diagnostics repair, and certification of electronic, mechanical, and radiation Test Measurement and Diagnostic Equipment (TMDE).

MAJOR DUTIES:

1. Serves as a Small Shop Chief performing all of the following tasks:
(a) Plans and lays out work to be accomplished in the shop, which is then completed by the individual and lower graded worker(s).
(b) Possesses the knowledge and skills found at the journeyman level as well as those required for planning, accomplishing, and maintaining a functional shop maintenance program.
(c) Independently determines appropriate maintenance procedures such as how and when the work should be accomplished. Estimates manpower, equipment, and material requirements.
(d) Devises and maintains program plans and records, is skilled in surveillance and troubleshooting techniques, and is able to determine maintenance/repair procedures needed without benefit of technical supervisory guidance.
(e) Plans, organizes, and directs shop maintenance programs/procedures under general supervision.
(f) Determines approaches, methods, and courses of action required to accomplish the mission of the shop in an effective and efficient manner.
(g) May provide recommendations and input to the supervisor concerning personnel actions such as performance appraisals, awards, position description changes, disciplinary actions, leave, etc.

2. Performs the same type and level of work as performed within the unit.

3. Performs other duties as assigned.

Conditions of employment

• NATIONAL GUARD MEMBERSHIP IS REQUIRED. If you are not sure you are eligible for military membership, please contact a National Guard recruiter prior to applying for this position.
• This is an excepted service position that requires membership in military assignment in WV's National Guard, and is required prior to the effective date of placement.
• Selectee will be required to wear the military uniform.
• Acceptance of an excepted service position constitutes concurrence with these requirements as a condition of employment.
• Male applicants born after 12/31/1959 and are required to register under the Military Selective Service Act, the Defense Authorization Act of 1986 requires that you be registered, or you are not eligible for appointment in this agency.
• Federal employment suitability as determined by a background investigation.
• May be required to successfully complete a 2 year probationary period.
• Participation in direct deposit is mandatory.
• U.S. Citizenship is required.
• Required to obtain and maintain a satisfactory security clearance, AND, as a minimum, a completed National Agency Check (NAC) prior to assignment.
• The agency will provide additional information regarding what information or documentation will be needed and how you can request of the agency a legally required exception from this requirement.
• Must be able to obtain and maintain the appropriate security clearance of the position.
• This position is covered by the Domestic Violence Misdemeanor Amendment (30 Sep 96) of the Gun Control Act (Lautenberg Amendment) of 1968.
• An individual convicted of a qualifying crime of domestic violence may not perform the duties of this position.
• Ability to establish effective professional working relationships with coworkers and customers, contributing to a cooperative working environment and successful accomplishment of the mission.
• Irregular and/or overtime (compensatory) hours may be required to support operational requirements or contingencies or may be required to work hours outside of the normal duty day.
• You are responsible to maintain awareness of your environmental responsibilities as dictated by legal and regulatory requirements, your organization, and its changing mission.

Qualifications

MINIMUM MILITARY GRADE: E6, WO1 MAXIMUM MILITARY GRADE: E9, CW2

Your rank MUST be included somewhere within your resume.

You must fully substantiate in your own words that you meet the requirements listed below. When explaining minimum requirements and specialized experience you must give examples. Do not copy from the vacancy announcement or the position description. Explain it in your own words and give examples to be considered for this vacancy.

All personnel applying for this position who do not meet the minimum military grade requirement MUST provide the proper signed memorandum from your respective Military Personnel Office (MILPO for ARNG, FSS for ANG) to prove eligibility to obtain the required grade upon accepting the position.

***ENLISTED ONLY***
All personnel who exceed the maximum military rank must provide a memorandum explaining if selected for this position, you will accept a voluntary reduction in rank. The memorandum must be submitted WITH your application to be considered for this position.

GENERAL EXPERIENCE: Experience or training which demonstrates a working knowledge of electronic principles involved in the generation and measurement of such elements as voltage, current, impedance, capacitance, frequency, and inductance. Experience in the use of various precision measurement instruments and standards.

SPECIALIZED EXPERIENCE: Experience or training with basic application of operating principles such as the production and utilization of oscillations over a broad range of frequencies; signal and waveform behavior, distortion, and amplification; pulse, trigger, and synchronization techniques; digital/analog processing and data conversion techniques; and a variety of display and indication methods. Experience in tracing signals and voltage paths, and skilled in the analysis of waveform characteristics such as timing, duration, frequency, and phasing. Originates test set-ups to isolate malfunctions and check performance characteristics of special or unique test panels or mockups. Experience in interpreting and applying a variety of technical electronic information such as schematic symbols, mathematical expressions and formulas, calibration procedures, and other reference materials. Experience in applying established techniques and methods of repair, testing, alignment, and calibration of equipment, which serves as test equipment or precision measurement standards. Experience in utilizing electronic circuits to measure electronic or electrical quantities to determine the performance characteristics and accuracy of other instruments and equipment.

How you will be evaluated

You will be evaluated for this job based on how well you meet the qualifications above.

Once the announcement has closed, your resume and supporting documentation will be used to determine if you meet the qualifications listed on this announcement. If you are minimally qualified, your documents will be compared to your responses on the assessment questionnaire to determine your level of experience.

• Plagiarism in an applicant's resume from any position description or qualification standard written by NGB or OPM will result in an automatic disqualification.
• HRO will not search for missing information or infer about aspects of an applicant's application. The information therein must be clear and unambiguous for an eligibility determination.
• DSG and M-Day applicants will be required to include their part-time experience or current status in the West Virginia National Guard in their resume to prove eligibility for Consideration in Area 3.
• All supporting documentation required for eligibility certification will be explicitly listed in the Required Documents section on USA Jobs. Applicants that fail to produce all documents listed in this section before the announcement closes will be disqualified.
• Resumes alone are not sufficient as proof of documentation.

If you are found eligible, you will be referred in numerical order of area of consideration to the hiring manager for employment consideration. If you are found eligible and were not referred to the hiring manager, then your application will be held until the hiring manager requests your respective area.

To apply for this position, you must submit a complete Application Package which includes:

If you do not submit these forms, you will be deemed ineligible, and your name will not be referred to the hiring manager.

1. Resume
   • Must provide Military Rank/Pay Grade for current members serving in the Armed Forces.
   • Include DSG/M-Day assignment information or provide other supporting documentation (v-MPF RIP, NGB 23A, etc.)
   • Cannot exceed 2 pages
2. SF-50, AGR Orders, or ADOS Orders (Only if you are a fulltime employee of the National Guard)
   • Must be up-to-date and current
3. Transcripts/Degree (If you wish to be certified based on education)
4. Certification (If it is required in this announcement)

Your responses to the Qualifications Questionnaire; this questionnaire is filled out via the USA Jobs Announcement through www.usajobs.gov. ALL applications and supporting documents MUST be submitted through www.usajobs.gov electronically and must be submitted prior to midnight of the closing date. Mailed, e-mailed, hand-delivered, and faxed applications will NOT be accepted or considered. Missing required documents will prevent you from being found eligible for this position and will prevent you from being referred to the hiring manager.

DO NOT SUBMIT MEDICAL DOCUMENTATION

Next steps